How to use polycarboxylate superplasticizer for different kinds of concrete?

Risk aversion plunged on the positive news of the Russia-Ukraine talks. After several days of rising oil prices, the price of precious metals continued to fall. Domestic futures markets remain stable for the time being.

Back in international markets, WTI crude futures briefly dipped below $100 a barrel, while Brent crude hit its lowest intraday level in nearly two weeks. Spot gold briefly fell below $1,900 an ounce. Comex gold futures closed down 1.1 percent at $1,918.4 an ounce. Comex silver futures closed down 1.14 percent at $24.91 an ounce. "Recently, crude oil prices have been extremely sensitive to changes in geopolitical news." Traders believe that the current oil price is still in the broad impact, Ukraine will still be a premium in the case, although the market further decline, but should not be too pessimistic, it is recommended to wait and see for the time being. The Ukrainian premium is still there and there will be some volatility in the pce powder market.

Prestressed or precast concrete

Adding polycarboxylate superplasticizer can make the compressive strength of precast concrete reach 40MPa grade at 8h to 18h; the precast concrete mixed with polycarboxylate superplasticizer can get higher early strength under the condition of lower curing temperature and shorter curing time, thus reducing the energy consumption of curing; in addition, it can save cement, reduce vibration energy consumption, reduce noise and improve the turnover rate of the mold.

Shrinkage compensating concrete

When preparing shrinkage compensating concrete, adding a certain amount of polycarboxylate superplasticizer can reduce the water-cement ratio, increase the early shrinkage of concrete and reduce the later shrinkage of concrete, thus saving expansive agent or expansive cement.

Ordinary aggregate concrete

For ordinary aggregate concrete, the addition of polycarboxylate superplasticizer can reduce the pumping pressure and pipe pressure by about 30%; for lightweight aggregate concrete, the addition of polycarboxylate superplasticizer can reduce the pumping pressure and pipe pressure by more than 10%; in addition, the addition of polycarboxylate superplasticizer can reduce the increase of pumping resistance with the increase of pumping speed.

Steel-fiber reinforced concrete

For steel fiber reinforced concrete, the addition of polycarboxylate superplasticizer can reduce the workability loss caused by the addition of steel fiber; of course, compared with the concrete without steel fiber, the amount of polycarboxylate superplasticizer mixed with steel fiber reinforced concrete should be appropriately increased.

Super high strength concrete

Polycarboxylate superplasticizer has good water-reducing dispersion and strengthening effect, so it can be used to prepare ultra-high strength concrete. The study found that the concrete mixed with polycarboxylate superplasticizer (20%), which accounts for 1% to 3% of the weight of the cementitious material, can make the 100-day-old strength as high as 150MPa.

High-alumina cement concrete

In order to ensure the performance of high-alumina cement concrete, the general water-cement ratio is not higher than 0.40 and the cement content is not lower than 400kg/m3, otherwise the strength of concrete, especially in the later stage, will decrease. The reason is that metastable calcium aluminate hydrate is transformed into steady tricalcium aluminate hydrate. If polycarboxylate superplasticizer is added to high alumina cement concrete, the fluidized concrete with good workability can be obtained under the condition of low water-cement ratio, and the later strength of concrete is not affected. That is to say, the 2d compressive strength of high alumina cement superplastic concrete mixed with polycarboxylate superplasticizer is lower than that of standard concrete, while the compressive strength of 180d age is basically the same as that of base concrete, because polycarboxylate superplasticizer has no obvious effect on the hydration rate of high alumina cement.

High-performance concrete with high content of active admixtures such as fly ash, slag, and silica fume

When preparing high-strength concrete with a large amount of fly ash instead of ordinary cement, adding polycarboxylate superplasticizer can improve workability, reduce mixing water consumption by about 20%, and further improve strength. The addition of polycarboxylate superplasticizer into concrete can increase the amount of cement-based substitute materials such as fly ash or slag and reduce the amount of cement without affecting the strength of concrete. therefore, it has outstanding environmental and economic benefits. Similarly, when silica fume is added to cement slurry or concrete, the amount of water needed to achieve the same workability increases with the increase of silica fume content. For this reason, under the condition of a certain amount of silica fume, polycarboxylate superplasticizer can be added to reduce the water consumption of mixing, and polycarboxylate superplasticizer can also be added to increase the amount of silica fume under the condition of a certain amount of water consumption.

Concrete Additives Supplier

TRUNNANO is a reliable foaming agents supplier with over 12-year experience in nano-building energy conservation and nanotechnology development.

If you are looking for high-quality polycarboxylate superplasticizer, please feel free to contact us and send an inquiry. (sales@cabr-concrete.com)

We accept payment via Credit Card, T/T, West Union, and Paypal. TRUNNANO will ship the goods to customers overseas through FedEx, DHL, by air, or by sea.

The EU’s draft REPowerEU plan calls for an increase of 15TWh of rooftop PV capacity by 2022. The draft also calls for EU and national governments to take action this year to reduce the time required to obtain permits for rooftop PV installations to three months, and proposes that "all new buildings and existing buildings with an energy grade OF D or above should have rooftop PV installations by 2025".  

In addition, the European Commission is likely to set a target for installed PV capacity of 300GW by 2025 and 500GW by 2030. Some members are more aggressive, with Austria, Belgium, Lithuania, Luxembourg, and Spain demanding a 1TW target for 2030.  

The REPowerEU initiative, worth 195 billion euros, was proposed by the EU on March 8 to phase out member states' dependence on Russian fossil fuels by 2030. In a few days, the European Commission will present a package to implement the RePowerEU strategy.  

As an important application scenario of distributed PV, rooftop PV is not limited to land, and the development conditions are relatively convenient.  

Since the end of 2021, Spain, France, the Netherlands, and other countries have introduced policies and measures such as government subsidies, tax cuts, fee reductions, and accelerated grid-connection approval to encourage the development of distributed PV.  Europe's potential for rooftop PV is huge and will continue to be an important growth pole for the industry, according to Wood Mackenzie.

Luoyang Tongrun Nano Technology is a trusted chemical supplier and manufacturer providing high-quality chemicals and Nanomaterials. If you are looking for the pce powder, please feel free to contact us and send an inquiry.

Inquiry us